Distributor drive gear install on vw 1600 vwdarrin. how to install a volkswagen distributor. - duration: 12:15. 6:49. vw type 1 distributer drive gear install - duration: 5:07.. The distributor drive is a little shaft with a gear on the end of it that meshes with a gear on the crankshaft. your first task is to be sure there's not one in there already.. I install the drive gear and distributor before the crank goes in, set it to where it should point, and then drop the crank in, holding #1 rod up. i went to school per vw in 69. we were tough to install the drive gear after the case was together. install the shime with a grease coating on each side. this will hold it in place. face the slot.
Building up a longblock the longblock includes the oil cooler, but not the cooler adapter. the engine does not come with distributor drive pinion (you must install one - though for a small fee aircooled.net will install it for you). it may be necessary to turn the rotor slightly to mesh the slot in the distributor shaft with the tab at. How do you remove a distributor drive shaft from the engine block once it has been put into place incorrectly without having to buy that special vw tool that cost about $60 (i have already spent more than i can afford on parts to put this thing back together).. A pesky distributor driveshaft you need to remove the fuel pump pump push rod and the plastic guide them you can remove the distributor drive. the fuel pump is driven off of the distributor drive, that's why it would only move a little bit. if the shaft has a lot of endplay the distributor may be the real problem..
